4. Lock the bottle in place by turning the developer bottle cap about 160
direction of the arrow until it stops.
Figure 4-21. Replacing the Developer Mix (11)
!
CAUTION
Hold the developer bottle when you turn the cap so that the bottle does not
turn along with the cap.
Incorrect setting of the Developer Bottle can cause damage to the
Developer Unit. Make sure the Developer Bottle is properly seated before
going to the next step.
5. To start the supply process, make the following selections from the OCP:
Setup / Consumable / Developer Mix / Supply /
Figure 4-22. Replacing the Developer Mix (12)
°
in the
Care and Maintenance 4-13