Table of Contents
Advertisement
8. Turn the bottle cap back about 160
remove the developer bottle.
Figure 4-26. Replacing the Developer Mix (16)
9. Place the cap back on the developer duct.
10.If the developer spills out, wipe it away thoroughly
:
NOTE
Do not dispose of the empty developer bottle after replacing. Keep it until next developer
replacement because it will be used at that point.
!
CAUTION
If the developer spills on the floor, the floor may become slippery. Immediately clean up
any spilled developer with a toner-safe vacuum cleaner.
If the developer gets into your eyes, immediately rinse with running water. Injury may
occur if developer remains in the eyes. If developer comes in contact with skin or clothing
wash with soap and water
in the direction of the arrow until it stops and
°
Care and Maintenance 4-15
Advertisement
Table of Contents
Troubleshooting
