Ricoh EMP 156 User Manual page 163

Message
HCF2 Lower Open
Close Tray E045
HCF2 Lower Paper Height Error
Reload Paper E0C3
HCF2 Lower Size Mismatch
Load xxx E0C2
HCF2 Top Cover Open
Close Cover E05C
HCF2 Upper Open
Close Tray E046
HCF2 Upper Paper Height Error
Reload Paper E0C5
HCF2 Upper Size Mismatch
Load xxx E0C4
HR End of Life
Replace HR E01F
OPC End
Replace OPC E022
OPC Near End
Replace OPC E021
OPC Sheet End of Life
Wind OPC Sheet E01D
Paper in CCD1
Remove Paper E072
Paper in CCD2
Remove Paper E073
Paper in CS1 Lower
Remove Paper E0A8
Paper in CS1 Path 1
Remove Paper E0A2
Paper in CS1 Path 2
Remove Paper E0A3
Paper in CS1 Path 3
Remove Paper E0A4
Paper in CS1 Path 4
Remove Paper E0A5
Paper in CS1 Path 5
Remove Paper E0A6
Paper in CS1 Path 6
Remove Paper E0A7
Paper in CS1 Upper
Remove Paper E0A9
Paper in CS2 Lower
Remove Paper E0B0
Paper in CS2 Path 1
Remove Paper E0AA
Paper in CS2 Path 2
Remove Paper E0AB
Paper in CS2 Path 3
Remove Paper E0AC
Paper in CS2 Path 4
Remove Paper E0AD
Description
HCF2 Lower is opened.
Paper height in HCF2 Lower is
incorrect.
Incorrect paper size is loaded in HCF2
Lower. xxx is the paper size.
HCF2 Top Cover is opened.
HCF2 Upper is opened.
Paper height in HCF2 Upper is
incorrect.
Incorrect paper size is loaded in HCF2
Upper. xxx is the paper size.
Heat Roll needs to be replaced.
OPC Sheet needs to be replaced.
OPC Sheet needs to be replaced.
OPC sheet needs to be winded.
There is paper on the CCD1 Sensor.
There is paper on the CCD2 Sensor.
There is paper in the CS1 Lower.
There is paper in the CS1 Path 1.
There is paper in the CS1 Path 2.
There is paper in the CS1 Path 3.
There is paper in the CS1 Path 4.
There is paper in the CS1 Path 5.
There is paper in the CS1 Path 6.
There is paper in the CS1 Upper.
There is paper in the CS2 Lower.
There is paper in the CS2 Path 1.
There is paper in the CS2 Path 2.
There is paper in the CS2 Path 3.
There is paper in the CS2 Path 4.
Corrective Action
Close the HCF2 Lower.
Refer to "General Printing Problems"
on page 5-4.
Load requested size paper in HCF2
Lower.
Close the HCF2 Top Cover.
Close the HCF2 Upper.
Refer to "General Printing Problems"
on page 5-4.
Load requested size paper in HCF2
Upper.
Contact your authorized Service
Technician.
Contact your authorized Service
Technician.
Contact your authorized Service
Technician.
Wind OPC sheet.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Remove the paper.
Troubleshooting 5-13