Table of Contents
Advertisement
Using the Front Panel Keypad
Please take a moment to familiarize yourself with the keypad layout shown in the figure
below. The display is used in programming the inverter's parameters, as well as monitoring
specific parameter values during operation.
(8) 7-seg LED
(7) Run command LED
(9) RUN key
(11) ESC key
Key and Indicator Legend
Items
(1) POWER LED
(2) ALARM LED
(3) Program LED
(4) RUN LED
(5) Monitor LED [Hz]
(6) Monitor LED [A]
(7) Run command LED
(8) 7-seg LED
(9) RUN key
(10) STOP/RESET key
(11) ESC key
(12) Up key
(13) Down key
(14) SET key
(15) USB connector
(16) RJ45 connector
(4) RUN LED
(5) Monitor LED [Hz]
(6) Monitor LED [A]
8888
RUN
1
ESC
2
(12) Up key
(13) Down key
Turns ON (Green) while the inverter is powered up.
Turns ON (Red) when the inverter trips.
Turns ON (Green) when the display shows changeable parameter.
Blinks when there is a mismatch in setting.
Turns ON (Green) when the inverter is driving the motor.
Turns ON (Green) when the displayed data is frequency related.
Turns ON (Green) when the displayed data is current related.
Turns ON (Green) when the RUN command source is set to the operator. (Run key is
effective.)
Shows each parameter, monitors etc.
Makes inverter run.
Makes inverter stop, according to parameter setup.
Reset the inverter when it is in trip situation
Go to the top of next function group, when a function mode is shown
Cancel the setting and return to the function code, when a data is shown
Moves the cursor to a digit left, when it is in digit-to-digit setting mode
Pressing for 1 second leads to display data of d001, regardless of current display.
Increase or decrease the data.
Pressing the both keys at the same time gives you the digit-to-digit edit.
Go to the data display mode when a function code is shown
Stores the data and go back to show the function code, when data is shown.
Moves the cursor to a digit right, when it is in digit-to-digit display mode
Connect USB connector (mini-B) for using PC communication
Connect RJ45 jack for remote operator
RUN
PWR
Hz
ALM
A
PRG
STOP/
RESET
SET
(14) SET key
Contents
10
(1) POWER LED
(2) ALARM LED
(3) Program LED
(15) USB connector
(10) STOP/RESET key
(16) RJ45 connector
Advertisement
Table of Contents
