Fluke 91 Series II User Manual page 160

ScopeMeter Test Tool Tutorial
C. MAKING CURSOR PHASE MEASUREMENTS
In addition to the previous connection, also connect the
grey scope probe from INPUT B to TP2.
1. Press .
2. Use of both inputs to see the two waveforms
on the display.
3. Press to freeze the display.
(If the display shows glitches on INPUT B, press
twice more until they disappear; otherwise, incorrect
measurements will be made).
4. Press to open the MORE SCOPE window.
5. Press for page 2.
Now select the phase measurement as main reading:
6 Use to highlight ADD MAIN READING, and
press to open the list box.
7. Use to highlight "phase A>B", and press
to select.
You have now selected a phase measurement, but to see
where it will actually occur it is best to activate the markers.
8. Press for page 3.
9. Press to open the SET MARKERS list box.
10. Use to highlight "phase", and press
select.
11. Press to close the window.
You should now have a display that looks like Figure 8-20.
Figure 8-20 Phase Measurement
8 - 31
to