Fluke 91 Series II User Manual page 131

8 - 2
This chapter demonstrates how to use several of the
advanced features of your ScopeMeter test tool. To
become familiar with these features, you must use the
Demonstration Board. All the following tutorials (except
"Testing Potentiometers") require that you connect the test
tool to the relevant test points (TP1 through TP5) on the
"Demo Board". In "Testing potentiometers" you must supply
your own potentiometer.
Before making any measurement, be aware of the safety
precautions on page VIII. The Demo Board connections
are shown in Figure 8-1.
91/92/96/99/105
All displays shown in the example figures are typical
values. Actual measured values may vary because the
Demo Board signal levels are dependent on the battery
voltage.
TO AVOID ELECTRIC SHOCK OR FIRE:
• USE ONLY THE TEST LEAD/PROBE SET SUPPLIED
WITH THE SCOPEMETER
SAFETY-DESIGNED EQUIVALENTS) WITHOUT EX-
POSED METAL CONNECTORS.
• USE ONLY ONE COM (COMMON) CONNECTION.
REMOVE ALL PROBES AND TEST LEADS THAT
•
ARE NOT IN USE.
Users Manual
NOTE
WARNING
TEST TOOL (OR