Fluke 91 Series II User Manual page 150

ScopeMeter Test Tool Tutorial
To start the Single Shot measurement:
10. Press
The display is first cleared, the rising edge of the pulse is
now captured, and the ScopeMeter test tool has returned
to the HOLD mode (see Figure 8-14). To capture the falling
edge of the pulse in the Single Shot mode:
11. Press .
12. Press to select the - SLOPE.
13. Press to start the Single Shot.
You can now see the difference in the speed of the rising
and falling edges of this waveform. Note that in the Startup
menu window you can configure the ScopeMeter test tool
to clear the display each time a new Single Shot is started.
To find the Startup menu from the More User Options
window, first press , and then .
Figure 8-14 Single Shot Measurement
8 - 21