2 - 10
If you have not already done so, perform a
1.
Input A
2.
3.
4.
Input A
5.
+
Set the Display to 3V manual range, about "3.412 Vrms AC" and "+2.127 V DC" appear, and the
amplitude of the graphical representation increases.
Press this key once to measure a stable display. TOUCH HOLD appears in the top right of the
display.
Press this key once again to resume new measurements.
Press this key. The display changes to 1V range. The voltage readings are overloaded, and
"OL Vrms AC" and "+OL V DC" appear.
The test tool automatically assumes a new setup that is optimized for measuring the actual
input signal.
PERFORMING SOME METER OPERATIONS
reset.
91/92/96/99/105
Users Manual
Continued on next page