2 - 6
USING THE DEMONSTRATION (DEMO)
BOARD
During the Quick Measurements, Quick Meter Operations,
and Quick Scope Operations, you use the Demo Board
that is included in your ScopeMeter test tool kit. Before
doing any measurement, review the safety precautions in
the beginning of this manual. Refer to Figure 2-2 for the
setup of this demonstration.
•
Connect the red scope probe to TP2.
Continue with the Quick Measurements Demonstration for
more hands-on training using active waveforms.
The displays and measurements are typical. They will vary
depending on the condition of the Demo Board battery.
Figure 2-2 Demonstration setup
91/92/96/99/105
Users Manual
NOTE