Fluke 91 Series II User Manual page 13

XII
PREPARING TO USE THE DEMONSTRATION (DEMO) BOARD
A Demo Board with 9V battery is included in your ScopeMeter test tool kit. It generates different types of waveforms that can
be measured at test points TP1 to TP5. All descriptions and measurement examples refer to a waveform that can be
measured on the Demo Board.
Do not connect the Demo Board yet, but when you make measurements, do the following:
• Place the Demo Board on a non-conductive surface.
• Connect the 9-volt battery, and make sure that polarity is correct.
The displays and measurements shown in this manual are typical. They will vary depending on the condition of the Demo
Board battery.
91/92/96/99/105 Users Manual