Selection Info (With More Than One Track Selected) - Euphonix R-1 Operation Manual

Euphonix Version 4 Supplement to the R-1 Operation Manual
6.3.3

Selection Info (with more than one track selected)

Parameter
Name
The time position at
Start Time which the selection
area starts
The on/off (enabled/
Start Time disabled) status of a
Enable selection start time
other than Zero.
The time position at
End Time which the selection
area ends
The on/off
(enabled/disabled)
End Time
status of a selection
Enable
end time other than
24:00.
The length of time
Selection from the Selection
Length Start point to the
Selection End point.
The number of Tracks
Tracks
with the Selection
Selected
region.
Table 6-3 Selection Info
Meaning Editable
Yes
Switchable
Yes
Yes
Yes
Adjustable
elsewhere
Editing and Selection Features
Comments and Constraints
This value is retained (and displayed) even
when it is not being used (i.e. it is disabled).
If Start Time is disabled then the Start Time
is automatically set to zero.
Use the Store Start (Enable) key to quickly
enter this value at the current position, then
use this Info Panel to precisely adjust the
Start Time in small increments.
When the Start Time is off the selection area
automatically starts at zero.
With both Start and End Times disabled the
entire Track is selected.
Use Wave + (Store) Start Enable key to tog-
gle the Start Time status from enabled to dis-
abled and vice versa.
This value is retained (and displayed) even
when it is not being used (i.e. it is disabled).
If End Time is disabled then the End Time is
automatically set to 24:00.
Use the Store End (Enable) key to quickly
enter this value at the current position, then
use this Info Panel to precisely adjust the
End Time in small increments.
When the Selection Start Time is off the
selection area automatically starts at zero.
With both Start and End Times disabled the
entire Track is selected.
Use Wave + (Store) Start Enable key to tog-
gle the Selection Start Time status from
enabled to disabled and vice versa.
Editing this parameter changes the Selection
End Point.
If Selection End point is disabled then the
Selection End point will be modified, but the
actual selection area will not be changed.
This number primarily for informational pur-
poses and changes according to Track
selection operations happening outside of
the Selection Info panel.
62