Emerson E2 Installation And Operation Manual page 220

Alarm Name
Application Setpoint Has Changed 99
Application Was Created
Application Was Deleted
ARTC/MultiFlex RTU Override
Switch Stuck
ARTC/MultiFlex RTU Reset From
Power Failure
Attempt To Write Past Mem. EOB 50
Average Log Stuck-No Memory
Bad Modem
Battery backed memory lost
Batt Runtime Limit
Binding Input To Output Failed
BIOS/BIOS Ext. Update Failed
BIOS/BIOS Extension Updated
Can't Set Hardware Clock
Case Cleaning Was Started
Case Temp Hi Limit Exceeded
Case Temp Low Limit Exceeded
Cell Config Not Restored
Cell Create Failed For Restore
Checkit Sensor Has Failed
Checkit Sensor Is Alarming
Checkit Sensor Is In Notice
•
C-2 E2 RX/BX/CX I&O Manual
Default
Priority
A user has changed a setpoint in one of E2's applica-
tions.
99 A user has created a new application in this E2.
99 A user has deleted an existing application in this E2.
20 An override switch on an ARTC/ MultiFlex RTU has
been ON for a prolonged period of time, suggesting a
possible switch failure.
50 An ARTC/MultiFlex RTU lost power and reset when
power was restored.
The E2 attempted to write data to memory, but the
memory was full.
15 The Average Log cannot be written because there is
not enough memory.
20 The modem on this E2 is not functioning properly.
30 Battery backed memory loss not due to cleanout.
99 Battery runtime has exceeded 80% of the battery life-
time.
20 A valid connection could not be made between an
input and an output.
20 An update to the E2's BIOS has failed.
50 The E2's BIOS was successfully updated.
20 The E2 is unable to change the time on its hardware
clock.
User A case circuit has entered clean mode.
User A single temperature sensor in a Standard Circuit or
Case Control Circuit is recording a temperature
higher than its defined case temperature high set-
point.
User A single temperature sensor in a Standard Circuit or
Case Control Circuit is recording a temperature lower
than its defined case temperature low setpoint.
15 E2's attempt to restore configuration data to its appli-
cations has failed.
20 E2 attempted to create new applications as part of the
configuration restoration process and failed to do so
successfully.
User A Checkit sensor is returning an invalid temperature
value, indicating a sensor failure.
User A Checkit sensor on a Suction Group application is
recording a high temperature.
User A Checkit sensor's temperature is above its pro-
grammed notice setpoint.
Definition
026-1610 Rev 12 25-APR-2011