FARGO electronics HDP600 User Manual page 7

RESTRICTED USE ONLY
Adjusting the Transfer Dwell Time and Transfer Temperature _____________________________ 7-71
Selecting the Sensors button and Defaults button________________________________________ 7-71
Selecting the Sensors button and Defaults button________________________________________ 7-72
Section 8: Cleaning ________________________________________________________ 8-1
Table of Contents ___________________________________________________________________ 8-1
Using the Required Supplies ________________________________________________________ 8-2
Safety Messages (review carefully)______________________________________________________ 8-3
Cleaning inside the Printer __________________________________________________________ 8-4
Cleaning outside the Printer _________________________________________________________ 8-4
Cleaning the Printhead _____________________________________________________________ 8-5
Replacing the Card Cleaning Tape ____________________________________________________ 8-6
Cleaning the Magnetic Encoder ______________________________________________________ 8-8
Cleaning the Platen and Transfer Rollers ______________________________________________ 8-10
Cleaning the Transfer Rollers using the Cleaning Card ___________________________________ 8-11
Section 9: Packing the Card Printer__________________________________________ 9-12
Section 10: Board Level Diagnostics _________________________________________ 10-1
Board Errors ______________________________________________________________________ 10-2
Resolving the EE Memory Error ____________________________________________________ 10-2
Resolving the EE Checksum Error ___________________________________________________ 10-2
Resolving the DRAM Memory Error _________________________________________________ 10-3
Resolving the RAM Memory Error __________________________________________________ 10-3
Resolving the FPGA Error _________________________________________________________ 10-4
Sensor Testing _____________________________________________________________________ 10-4
Reviewing the Sensor Locations and Voltages__________________________________________ 10-5
Reviewing the Motor Locations and Cables____________________________________________ 10-7
Section 11: LCD On-Line Menu Navigation ___________________________________ 11-1
Entering the LCD Menu and selecting an Option __________________________________________ 11-1
Selecting from the HDP600 Menu Option Structure Tree _________________________________ 11-2
Reviewing the Printer Setup __________________________________________________________ 11-3
Preparing to Adjust the Print Offset, Transfer TOF and Transfer EOF _______________________ 11-5
Aligning the Print Offset __________________________________________________________ 11-6
Setting the Transfer TOF __________________________________________________________ 11-8
Setting the Transfer EOF _________________________________________________________ 11-10
Using the Gap Distance Table _____________________________________________________ 11-12
Adjusting the Transfer Tension ____________________________________________________ 11-15
Adjusting the Film Drive _________________________________________________________ 11-16
Adjusting the Ribbon Tension _____________________________________________________ 11-16
Adjusting the Ribbon Drive _______________________________________________________ 11-17
Adjusting the Transfer Temperature_________________________________________________ 11-17
Adjusting the Transfer Speed ______________________________________________________ 11-18
Setting the Printhead Resistance____________________________________________________ 11-18
Adjusting the Image Darkness _____________________________________________________ 11-19
Changing the Encoder Settings_____________________________________________________ 11-20
Setting the Magnetic TOF ________________________________________________________ 11-21
Setting the Magnetic TOF ________________________________________________________ 11-23
Adjusting the Flipper Offset _______________________________________________________ 11-24
Adjusting the Lamination Flipper Offset _____________________________________________ 11-25
Adjusting the LAM TOF and EOF __________________________________________________ 11-26
Adjusting the Lamination Sensor Calibration__________________________________________ 11-27
Adjusting the Lamination Temperature Setting ________________________________________ 11-27
Using the Show Card Count option _________________________________________________ 11-28
System Upgrade (Firmware Upgrade) _______________________________________________ 11-29
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
Fargo Electronics, Inc.
vii