FARGO electronics HDP600 User Manual page 337

RESTRICTED USE ONLY
Updating the Main Firmware (continued)
Step Procedure
8 Wait: The Firmware update will now take a few minutes.
Check the Printer's LCD for the status. (Note: When the update is complete,
the LCD will indicate if the update was successful.)
9 If the Upgrade Successful is displayed, click on Exit on the Sending Update
to Printer dialog screen.
Press the Printer's Exit button.
10
11 When prompted, turn the Printer power OFF for a few seconds and then
back ON to complete the update process. (Note: As the Printer restarts, you
will see the new Firmware version appear on the LCD.)
12 a. If the upgrade was not successful, the LCD will either display Upgrade
Failed or Upgrade Firmware Now on boot up.
b. If you receive this message, try updating the Firmware again.
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
Fargo Electronics, Inc.
12-6