FARGO electronics HDP600 User Manual page 123

RESTRICTED USE ONLY
Reviewing LCD Messages (continued)
Message
Heater Timeout
Head Thermistor
IEEE 1284 Timeout
Magnetics Encoder not
installed.
Film Calibration Fail
Error
Flipper Jam Error
HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3)
Cause
The Transfer Roller was
unable to reach its goal
temperature.
The Printhead thermistor is
not functioning properly.
See the HDP600 Printhead
Replacement Procedure
procedure.
The Printer cannot
communicate properly with
your PC.
You are trying to send
encoding data but the Printer
is not configured with this
Encoder type.
One of the Film Sensors was
not able to properly calibrate.
Unable to align Flipper.
Fargo Electronics, Inc.
Solution
Turn the Printer OFF and ON to
reset and try reprinting.
If the problem persists, call for
technical assistance.

If the Printer is cold, allow it
to warm up to room
temperature.

Check the Printhead cable.

Replace the Printhead.
Verify that you are using the
proper print cable.
Check the Encoding Settings
menu under Setup Printer to
verify which Encoder are
currently activated.
Verify no film marks are under
the Film Sensors during
calibration.
If the problem persists, call for
technical assistance.
Check for obstruction.
If the problem persists, call for
technical assistance.
Continued on the next page
4-5