Table of Contents
Advertisement
5-4
Repair
Expansion Board Removal
Use the following steps to remove any installed expansion board(s):
1.
Remove the system unit cover as previously described.
Label and disconnect any cables connected to the board.
2.
Remove the screw that secures the board to the support bracket (see Figure 5-2).
3.
Set the screw aside (it will be used to secure the slot cover after the board is
removed).
4.
Pull the board out of the connector. Do not rock a PCI expansion board from side
to side to release it from the connector. Pull the board straight out of the
expansion slot.
5.
Place the slot cover over the slot and secure it with the slot cover screw.
6.
Replace the system unit cover.
Figure 5-2 Expansion Board Removal
Advertisement
Table of Contents
Troubleshooting
