Table of Contents
Advertisement
3-36
Option Installation
4.
Insert the device part way into the device slot in the front of the system unit,
connector end first (see Figure 3-31).
5.
Connect the device cables (see "Cabling an IDE Device," "Cabling a Diskette
Drive," or "Cabling an Internal SCSI Device").
Insert the device the rest of the way into the device slot, making sure that the
6.
locking tabs at the ends of the device latching rails snap into the brackets on each
side of the device slot.
Replace the system unit front panel (see "Replacing the Front Panel").
7.
8.
Replace the system unit cover.
9.
Run the Setup program to set the new configuration (see Section 2).
Figure 3-31 Inserting a Device
NOTE: If a 1.2-MB diskette drive was
installed, remove the protective cardboard insert
from the drive.
Advertisement
Table of Contents
Troubleshooting
