Table of Contents
Advertisement
3-6
Option Installation
Replacing the System Unit Cover
Replace the system unit cover as follows.
1.
Position the cover over the chassis with its front edge about one inch behind the
front of the chassis.
2.
Lower the cover onto the chassis, taking care to align the tabs on the sides of the
cover with the securing rails inside the unit frame (see Figure 3-4).
3.
Slide the cover forward to meet the front panel.
CAUTION: To prevent damage to system
cables, carefully tuck the cables out of the path
of the cover.
Figure 3-4 Aligning the Cover
NOTE: The cover fits tightly. If the cover does
not slide all the way to the front panel, place one
hand on the front of the unit while sliding the
cover forward from the rear.
Advertisement
Table of Contents
Troubleshooting
