Monitoring Capabilities; The Chassis Intrusion Notification Feature - NEC PowerMate Enterprise Manual

Monitoring Capabilities

Your PowerMate Enterprise computer has a chip mounted on the system board that
supports many new and advanced real-time monitoring capabilities used by DMI. This chip
(NEC MagicEye™ Technology) provides the following features:
T
an integrated temperature sensor with configurable interrupt generation based on
upper and lower temperature limits
T
a power supply monitor with configurable interrupt generation based on upper
and lower voltage limits
T
chassis intrusion detection with interrupt generation capabilities (see "Using the
Chassis Intrusion Notification Feature").
To take advantage of these features, DMI has expanded its interface in the following areas:
T
Interrupts may be enabled or disabled.
T
High and low limits can be set and are displayed for temperature and power
supply voltages.
T
Current readings are displayed for temperature, power supply voltages, and
chassis state.
T
Interrupts can be detected when "out of range" conditions occur. User prompts
are displayed to alert the user to a potentially harmful condition.

The Chassis Intrusion Notification Feature

LANDesk Client Manager allows you to monitor the system against chassis intrusion.
Whenever the chassis is opened, LANDesk Client Manager logs the intrusion and reports
the incident in a screen message the next time the system is booted. The message appears in
a LANDesk Client Manager Notification window. This window appears every time the
system is rebooted until the report is cleared.
Close the notification window to remove the message from the screen. Clear the message to
prevent it from appearing again the next time the system is rebooted.
To clear the message, follow these steps.
1. Access LANDesk Client Manager.
T
If the LANDesk Client Manager Notification window is still open, click
and then click the
T
From the Windows desktop, click
point to
LANDesk Client Manager opens.
Client Manager
LANDesk Client Manager
Setup and Operation
button.
Start on the taskbar, point to Programs,
, and click LANDesk Client Manager 3.0
2-33
,
Yes
.