Quantum Viking; Cd-Rom Jumper Settings; Nec 24X Cd-Rom Reader - NEC PowerMate Enterprise Manual

Quantum Viking

The Quantum Viking SCSI drive uses jumper blocks A3, A2, A1, and A0 to configure the
SCSI ID for the drive. See the documentation that comes with the drive for more
information on when to configure the drive. The SCSI ID jumpering is listed below.
T
SCSI ID=0, no jumpers
T
SCSI ID=1, A0 jumpered
T
SCSI ID=2, A1 jumpered
T
SCSI ID=3, A1 and A0 jumpered
T
SCSI ID=4, A2 jumpered
T
SCSI ID=5, A2 and A0 jumpered
T
SCSI ID=6, A2 and A1 jumpered
T
SCSI ID=7, A2, A1, and A0 jumpered
T
SCSI ID=8, A3 jumpered
T
SCSI ID=9, A3 and A0 jumpered
T
SCSI ID=10, A3 and A1 jumpered
T
SCSI ID=11, A3, A1, and A0 jumpered
T
SCSI ID=12, A3 and A2 jumpered
T
SCSI ID=13, A3, A2, and A0 jumpered
T
SCSI ID=14, A3, A2, and A1 jumpered
T
SCSI ID=15, A3, A2, A1, and A0 jumpered

CD-ROM JUMPER SETTINGS

Systems may come with a 24X CD-ROM reader. Jumper settings for each CD-ROM reader
are provided in the following sections.

NEC 24X CD-ROM Reader

The NEC twenty-four-speed CD-ROM reader has one jumper block on the back of the
reader. Jumpers on the block configure the reader as a master (factory set) or slave device.
Descriptions of the jumpers are as follows:
T
CS (cable select) — enables/disables the cable select feature. Factory set at
disabled (pins not jumpered).
T
SL (slave) — enables/disables the slave feature. Factory set at disabled (pins not
jumpered).
T
MA (master) — enables/disables the master feature. Factory set at enabled (pins
jumpered).
Jumper Settings B-5