Insertion/Extraction Latch; System Board Removal - NEC PowerMate Enterprise Manual

5-16 Repair

System Board Removal

Use the following steps to remove the system board:
1. Remove the system unit cover as previously described. Make sure that all external
cables have been disconnected.
If the system has an AGP board, remove it (see the instructions in "Removing the
2.
AGP Video Board" in this section).
Disconnect any internal cables connected to the system board.
3.
Lift the insertion/extraction latch up slightly and pull it away from the system unit.
4.
This releases the system board and slides it part way out of the system (see
Figure 5-14).
NOTE: Check that all cables are removed from
the system board before attempting to remove it
from the system.
Figure 5-14 Unlatching the System Board