JVC GR-DV2000 Instructions Manual page 77

EN 77
30. Images on the LCD
monitor appear dark or
whitish.
31. The rear of the LCD
monitor is hot.
32. The indicators and the
image color on the LCD
monitor are not clear.
33. The LCD monitor or
viewfinder indications
blink.
34. Colored bright spots
appear all over the LCD
monitor or the viewfindec
30. • In places subject to low 30. • Adjust the brightness and
temperature, images become angle of the LCD monitor
dark due to the (z_ ° pg. 18, 19).
characteristics of the LCD
rrrr)nitor. When this happens,
the displayed colors differ
from those that are actually
recorded. This is not a defect
of the camcorder.
• When the LCD monitor's
fluorescent light reaches the
end of its service life, images
on the LCD monitor become
dark, Consult your nearest
JVC dealen
31. •The light used to illuminate
the LCD monitor causes it to
become hot.
32. • This may occur when the
surface or the edge of the
LCD monitor is pressed.
33. • Certain Fade/Wipe effects,
certain modes of Prograrrr AE
with special effects, "DIS"
and other functions that
cannot be used together are
selected at the same time.
34. • The LCD monitor and the
viewfinder are made with
high-precision technology.
Howeve_ black spots or
bright spots of light (red,
green or blue) may appear
constantly on the LCD
monitor or the viewfinder.
These spots are not recorded
on the tape. This is not due
to any defect of the unit.
(Effective dots: mr)re than
99.99 %)
31. • Close the LCD monitor to
turn it off or set the Power
Switch to "OFF", and let the
unit cool down.
32.
33. ,, Re-read the sections
covering Fade/Wipe effects,
Program AE with special
effects and "DIS"
(Z_ _ pg. _0, _4
_7).
34.
CONTINUED ON NEXT PAGE