JVC GR-DV2000 Instructions Manual page 19

EN1 9
NOTES:
• When you use the L(D rnonitor outdoors in direct sunlight, the LCD monitor may be difficult to see. If this
happens, use the viewfind_r instead.
• The image will not appeal simultaneously in the LCD monitor and the viewfinder except during Intert_c_
Shooting.
• Tile cassette holder cannot be opened unless a power supply is attached.
• There may t_ a delay after you open the cassette holder cover until the cassette tlolder opens. Do not use fol_.
• Once the cassett_ holder is ck)sed, it recedes automatically. Wait until it recedes completely before closing
the cassette holder cove_
• The time required t*) calculate and display the r_maining tape length, and the accuracy ot the calculation,
may vary according to the type of tape used.
• "TAPE FND" appears when the tape reaches its end, and the powergoes offautomatically if left in this
condition for 5 minut_. "TAPE END" also appears when a cassett_ at its end is loaded.
• If the Record-Standby mode continues for 5 minute'b the camcorder'_ power shut* off automatically< T_) turn
the camcorder on again, push back and pull out tile viewfinder again or close and re-open the LCD monitol:
• When a bbnk portion is l_ft between r_corded scenes on the tape, the time codu is intenupted and error_
may occur when editing the tape. To aw*id this, refer to "Recording from the middle of a tape" (_ _ pg. 23).
• During recording, sound is not heard i}om the speake_ To hear the sound, connect optional headphones t_)
tile PHONE cont_ector. The sound volume is at the l_vel it was adjusted to during playback (_-_ pg. 4_)).
• To turn the tally lamp or beep sounds off, _° pg. 28, 31.
Self-Recording
JOURNALISTIC SHOOTING
In some situations, different shooting angles may provide
more dramatic results. Hold the camcorder in the desired
position and tilt the LCD monitor in the most convenient
direction. It can rotate 270" (90" downward, 180 °
upward).
INTERFACE SHOOTING
The person you shoot can view himself/herself in the LCD
monitor, and you can even shoot yourself while viewing
your own image in the L(D monitol:
Open the L(D monitor and tilt it upward to 180 ° so that it
faces i_rward. When the LCD monitor is tilted upward to
an angle of over approx. 105 °, the monitor image is
inverted vertically. If the viewfinder is pulled out at that
time, it also switches on.
Point the lens toward the subject (yourself when self-
recording) and start recording.
During Interface Shooting, the monitor image and
indications do not appear inverted as they would when
viewing a mirror.
NOTES:
• During Intert_ce Shootir_g_ the "Tape Running" indicator
and warning indications (_ pg. 87, 88) are the only
ones that are shown; they appeal rewrsed ill the display
as they wouhl when viewing a reinor, but are not
reversed ill the recording.
• The tape remaining indicator does not appear during
intert[_ce shooting. However, when the remaining time
r_aches 2 rninut_s, the indicator appear* showing the
remaining time: _'÷--r_ (blinking) "__-r_
(blinking) '* ÷ r_ (blinking;