JVC GR-DV2000 Instructions Manual page 67

"ogram
SELECTSCENES
Random Assemble Point the remote control at the camcorder_s renlote
Editing Menu sensor. Press PLAY (1_) and then press R.A.EDIT ON/
OFF on the remote control.
The Random Assemble Editing Menu appears.
If using a Fade/Wipe at the beginning of the scene,
press FADE/WIPE on the remote control.
• Cycle through the effects by pressing repeatedly,
and stop when tile one you want is displayed.
• You cannot use a Picture Wipe/Dissolve at the
beginning of Program 1.
At the beginning of the scene, press EDIT IN/OUT on
the remote control. The Edit-In position appears in
the Random Assemble Editing Menu.
At the end of the scene, press EDIT IN/OUT. The
Edit-Out position appears in the Random Assemble
Editing Menu.
If using a Fade/Wipe at the end of the scene, press
FADE/WIPE
• Cycle through the effects by pressing repeatedly,
Remote sensor and stop when tile one you want is displayed.
...--- • If you select a Fade/Wipe effect for an Edit-Out
_'- point, the effect is autonlatically applied to the
following Edit-In point.
• You cannot use a Picture Wipe/Dissolve at the end
of the last scene.
• When you use Fade/Wipe effects, that time is
included in the total time (this does not apply to
FADE Picture Wipe/Dissolve).
EDIT I1_ If using Playback Special Effects, press EFFECT
ON/OFF (_° pg. 64).
CANCEL Repeat steps 6 through_ 9 to regi ter, s additional scenes.
• To change previously registered points, press
CANCEL on the remote control. The registered
points disappeat, one at a time, from the most
recently registered point.
• If you are not using Fade/Wipe or Program AE with
special effects, repeat steps 6 and 7 only.
NOTES:
• When choosing a scene, set Edit-In and Fdit-Out points so that there is a relatively lmge difference between
them.
• If the search time for an in-point exceeds 5 minutes, the recording deck's Record-Standby mode will be
canceled and editing will not take place.
• If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in
the edited version.
• Since time codes register time only as accurately as seconds, the time code total time may not match the
total program time exactly.
• Turning off the camcorder'_ power erases all r_gistered Edit-hi and Edit-Out points.
• If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Dissolve or
Black & White Fader. In this case the Dissolve or Black & I/Vhite indicator begin, _ blinking., Once the next
Edit-In point is r_gistered, the effect is turned ofi] To cornbine these eflZcts, use S_pia or Monotone during
recording, then use tile Dissolve or Black & White Fader during Random Assemble Fditing.
• It is not possible to use Fade/Wipe effects and Program AE with special effects during Random Assemble
Fditing using a DV cable.