JVC GR-DV2000 Instructions Manual page 73

If, after following the steps in the chart below, tile problem still exists, please consult your nearest JVC dealer.
The camcorder is a microcorrrputet:controlled device. External noise and interference (from a TV, a radio, [
I
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
I
pacl<, AC Power Adapter/Battery Charger, etc.) and wait a few minutes; and then re-connect it and proceed
as usual from the beginning.
7. No power is supplied. 7. • The power is not connected 7. • Connect the AC Power
2. "SET DATE/TIMEY'
appears.
3. Recording cannot be
performed.
properly.
• The battery is dead.
• The LCD monitor is not open
fully or the viewfinder is not
pulled out when recording.
2,
• Tile built-in clock's
rechargeable lithium battery
is discharged.
• The previously set date/time
is erased.
3.
•Tile tape's erase protection
tab is set to "SAVE".
• The Power Switch is set to
"_" or "OFF".
• "TAPE END" appears.
• The cassette holder cover is
open.
Adapter/Charger securely
/:-_ pg. 9).
• Replace the dead battery
with a fully charged one
/z_ _ pg. 8, 9).
• (-)pen the LCD monitor fully
or pull out the viewfinder.
• Connect tile camcorder to
an AC outlet using the AC
Power Adapter/(harger for
over 24 hours to charge the
clock's lithium battery
/_-_° pg. 11).
• Set the tape's erase
protection tab to "REC"
/z_ _ pg. 12).
• Set the Power Switch to
"!_l" or "[_]"/:- _ pg. 14).
• Replace with new cassette
/_-_" pg. 12).
• Close the cassette holder
cover
4. There is no picture. 4. • The camcorder is not getting 4. * Turn the camcorder's power
power, or some ()tiler off a nd on again
malfunction exists. (:-_ pg. 18).
5. Some functions are not 5. • The Power Switch is set to 5. * Set the Power Switch to
available using the MENU "[] ". "[_" (z _ pg. 14).
wheel.
6. The i_)cus does not adjust 6.
automatically.
• Focus is set to tile Manual
mode.
• The recording was done in a
dark place, or the contrast
"_vas IoYv.
• The lens is dirty or covered
with condensation.
6. * Set Focus to tile Auto mode
(_-_ pg. 27).
• Clean the lens and check
the focus again (_-_°pg. 80h
CONTINUED ON NEXT PAGE