JVC GR-DV2000 Instructions Manual page 32

Power Switch
Button
Lock Button
Record _ Start/Stop Button
Display
4!-
When the Recording Start/Stop
Button or SNAPSHOT is pressed,
the tally lamp changes as shown:
Shooting
Mode Switch
Menu Screen
Self-Timer
indication
Self-1]mer
Once the camcorder is set, the can]corder operator Call
become part of the scene in a more natural way, adding
the final touch to a memorable picture.
Set the Power Switch to "[_" while pressing down
the Lock Button located on the switch. Pull out the
viewfinder fully or open the LCD monitor fully.
• You can tilt the LCD monitor upward to 180 so that
it faces forward and view yourself while self-
recording with the viewfinder pushed back.
Press the MENU wheel. The Menu Screen appears.
Rotate the MENU wheel to select "_ MANUAL",
and press it.
Rotate the MENU wheel to select "SELF-TIMER", and
press it. The Sub Menu appears. Rotate the MENU
wheel to select "ON _", and press it. Selection is
cr)mplete. Rotate the MENU wheel to select
"41RETURN", and press it twice to close the Menu
Screen.
To engage the Self-Timer fi)r video recording, press
the Recording Start/Stop Button. After 1 5 seconds, the
beep sounds and vide() recording starts. To stop Selg
Timer recording, press the Recording Start!Stop
Button again. The camcorder re-enters Record-
Standby mode.
OR
Press SNAPSHOT. After 1 5 seconds, the beep sounds
and snapshot recording starts. After that, the
camcorder re-enters Record-Standby mode.
To end Self-17mer recording, select "OFF" in step 4.
NOTE:
If "BEFP" and "TALLY" ar_ set to "OFF" (_ _°pg. _1), the
beep does not sound and the tally lamp does not light.
M[NU Wheel
Z Turns off
(Self-Timer snapshot re(-ording starts)
Begins blinking ._ Blinks quickly Stops blinking and stays on
(Self-Timer starts) (Self-Timer shooting (Self-Timer video re(-ord-ing starts)
J starts soon) .J
After approx. 15 sec.