JVC GR-DV2000 Instructions Manual page 43

Power Switch
Lock Button
Stop Button (11)
BLANK SEARCH Button
Display
BlankSearch
Helps you find where you should start recording in the
middle of a tape to avoid time code interruption
(_:_ pg. 2_).
I oad a tape (z_ pg. 12) and set the Power Switch to
"1_" while pressing down the Lock Button located
r)n the switch.
Press BLANK SEARCH
• "BLANK SEARCH" appears blinking and the
camcorder automatically starts reverse or forward
shuttle search, then stops at the spot which is about
3 seconds of tape before the beginning of the
detected blank portion.
To cancel Blank Search midway...
.... press II.
NOTES:
• In step 2,/{tile currentposition is at a blink p*_rtion tile
camcr)rd_r searches in tile r_ver_e direction, and if tile
cunent position is at a recorded portion the camcorder
searches in the forward direction.
• Blank Search does not work if "HFAD CIFANING
REQUIRFD. USE CLEANING (ASSETTF" has appeared
with the tape.
• If the beginning or end of the tape is reached during
Blank Search, the camc_;rder stops auto)maritally.
• A bbnk portion which is shorter than 5 second* ot tape
cannot be detected.
• Tile detected bbnk portion may be located between
recorded scenes. Bef_;re you start recording; make sure
there is no recorded scene after tile blank portion.