Audiodubbing - JVC GR-DV2000 Instructions Manual

Display
Audio Dub
Standby mode
MIC (external
Power Switch microphone
input) connector*
Speaker
PHONE
(headphone)
connector*
Remote
Stereo
microphone
* Located beneath the cover.
ENT]
AudioDubbing
The audio Uacl< can be customized only when recorded in
the 12-bit nlode (_= pg. 29).
NOTES:
• Audio Dubbing is not possible on a tape recordvd in 16-
bit audio, on a tape recorded in the LP mode or on a
blank portion of a tape.
• To perfom_ Audio Dubbinp> while watching on the
television, make c_)nnections (_-_ pg. 54).
Play back the tape to locate the point where editing
will start, then press PAUSE (ll).
While holding A.DUB (@) on the remote control,
press PAUSE (11). "11_" appears.
Press PlAY (1_), then begin "narrating".
Speak into the microphone.
• To pause dubbing, press PAUSE (llL
To end Audio Dubbing, press PAUSE (11), then STOP
(I).
To hear the dubbed sound during playback...
.... set "12BIT ,MODE" to "SOUND 2" or "MIX" in the
Menu Screen (_ pg. 41,42).
NOTES:
• Audio dubbing is also possib!e using an optional
microphone connected t*) the MId" connect*)r.
• Sound is not heard i)om the speaker during Audio
Dubbing. To hear sound, c_mnect optional headphones
to the PHONE c_mnect_*_:
• While an optional microphone is connected, the built-in
microphone is disabled.
• When editing, ont_* a tape that was recorded at 12-bit,
the old and new soundtracks are r_corded separately.
• If you dub onto a blank _pace on the tape, the sound
may be disrupted. Make sure y_)u only edit rec_)rded
areas.
• If feedback or howling occur* during TV pbyback, move
the camcorder's rnicn*phone away fn)m the TV,, or turn
down the TV's volume,
• If you chanRe fr_)m 12-bit to 16-bit in mid-recolding
and then use the tape for Audio Dubbing; it is not
effective frorn the point where 16-bit recording began.
• During Audio Dubbing_ when the tape moves to sc_nes
r_cordvd in the LP mode, scenes recorded in 16-bit
audio or a blank portion, Audio Dubbing st_ps
(_-_° pg. 87).
• To perform Audio Dubbing with a video unit connected
to the camcorder's AV connects)r, firq set "S/AV INPUT"
to "ON" in the Menu S_reen (U__ _pg. 41). Y_)u can hear
sound from the vide() unit using optional headphones,