JVC GR-DV2000 Instructions Manual page 10

1
Power Zoom Level"
Recording
Start/Stop button
Power Switch
Mode
Switch
Diopter
Adjustment
Control
Grip Adjustment
_ Separate tile Velcro strip.
Pass your right hand through the loop and grasp
the grip.
Adjust so that your thunrb and fingers can easily
operate the Recording Start/Stop Button and
Power Zoom Lever: Refasten the Velcro strip.
ViewfinderAdjustment
Set the Power Switch to "F]" or "_]" while
pressing down the Loci< Button located on the
switch. Set the Shooting Mode Switch to any
position.
Pull ()Lit the viewfinder fully and adjust it
manually for best viewability.
Turn the Diopter Adjustment Control until tile
indications in the viewfinder are clearly
focused.
Shoulder Strap Attachment
I ollowing the illustration, thread the strap
through the eyelet@, then fold it back and
thread it through the bucl<le@. Repeat the
procedure to attach tile other end of tile strap to
the other eyelet @, making sure tile strap is not
twisted.
Tripod M ounting
i lign the screw and camera direction stud on
the tripod with tile camera's mounting socket
and stud hole. Then tighten the screw.
• Some tripods are not equipped with studs.
CAUTION:
When using a tripod, be sure to open and
extend its
legs fully
to stabilize the
camcorder, To prevent damage to the unit
caused by falling over, do not use a small-
sized tripod.