JVC GR-DV2000 Instructions Manual page 53

MEMORY PLAY Button
MENU Wheel
Display
DPOF Screen
O
Confirmation
Screen
EN53
TO PRINT BY SELECTING STILL IMAGES
AND NO. OF PRINTS
Perform steps 1 through 5 on pg. 52.
Rotate the MENU wheel to selsect "SELECTED" and
press it. Selection is complete. The DP(-)F Screen
appears.
Rotate the MENU wheel to move the green frame to
tile image you wish to print and press it.
Select the number of prints by rotating the MENU
wheel towards "+" to increase the numbeB or
towards "-" to decrease the number and press it.
Repeat steps 3 and 4 for the desired number of prints.
• The number of prints car/be set up to 15.
• To correct the number of prints, select the image
again and change the number.
Rotate the MENU wheel upward to select "EXIT" and
press it. Selection is complete. The ( onfirmation
Screen appears.
Rotate the MENU wheel to select "EXECUTE" and
press it. The normal playbacl< screen appears.
• To cancel selection, rotate the MENU wheel to
select "( ANCEL" and press it.
To Reset The No. Of Prints... .
.... select "RESET" in step 6 on pg. 52. The number of
prints is reset to 0 for all still images.
CAUTION:
While performing tile above, never disconnect power,
as this may cause the memory to be corrupted. For
safety, all buttons including the Power Switch are
disabled in step 5.
NOTES:
• If you load a memory card already set as shown above
in a printer compatibl_ with DPOF, it will rnake prints ot
the selected still images automatically.
• To print images r_cord_d on a tape, firq dub them to a
mernory card (_ _ pg. 60).