Model Code Definition - Mitsubishi Electric Melservo-J2-SUPER series Instruction Manual

1. FUNCTIONS AND CONFIGURATION
Function
Analog monitor
Alarm history
I/O signal selection (Device setting)
Torque limit
Override (speed limit)
Status display
Test operation mode
Limit switch
Software limit

1.4 Model code definition

(1) Rating plate
MITSUBISHI
MODEL
MR-J2S-60CL
POWER : 600W
POWER
INPUT : 3.2A 3PH 1PH200-230V 50Hz
3PH 1PH200-230V 60Hz
5.5A 1PH 230V 50/60Hz
OUTPUT : 170V 0-360Hz 3.6A
SERIAL : A5
TC3 AAAAG52
MITSUBISHI ELECTRIC CORPORATION
MADE IN JAPAN
The servo status is output in terms of voltage in real time.
By using the Servo configuration Software, the current alarm and
five past alarm numbers are stored and displayed.
By using the Servo configuration Software, any devices can be
assigned to 9 input, 5 output and 1 I/O pins.
Servo motor-torque is limited.
Parameter 2 limit value
Analog input
The servo motor speed is limited by analog input.
The ratio of override to the set speed can be changed between 0 to
200%.
The servo status is displayed.
Jog, Positioning, Operation w/o motor, Forced output, Program
test
The servo motor travel region can be limited using the forward
rotation stroke end (LSP)/reverse rotation stroke end (LSN).
The travel region is limited using parameters in terms of address.
The function similar to that of a limit switch is limited by
parameter.
AC SERVO
AC SERVO
PASSED
Description
1 limit value
Model
Capacity
Applicable power supply
Rated output current
Serial number
1 - 12
Reference
Section 5.2.4
Section 6.8
Section 6.6
Section 3.2.5
Section 3.2.4
Section 7.2
Section 6.7
Section 5.2.5
Section 5.2.9