Advertisement
2
_To
install bagger components
to tractor
1.
Discharge Chute
2.
3/8 Nut
3.
Flat Washer
3
1. SupportBracket
2. 3/8 Carriage Bolt
1
3. 3/8 Lock Nut
5
4. 3/8 x 63,5mm He0(Bolt
5.
lO,3mm
(13/32")
flat
washer
2
1,
2.
3.
Removedischarge chutefrom rearoftractor. Unhookthe
two(2) straps and pullchute out and away from tractor.
Removethe two (2) 3/8 nuts and flat washers from the
boltsat the tractorbackplate.
3/8 Lock nut
Flat Washer
Support Tube
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tuba to the back
plate as shown. Tighten securely.
•
Install the two upper support brackets through the back
plate and to the chassis, usingthe 10 x 19 mm (3/8"x3/4")
cardage bolts and Iocknuts supplied. Tighten securely.
•
Assemble both support brackets to the outside of the
baggger support tube using two each 3/8 x 63,5mm hex
bolts13/32" I.D. fiat washers and 3/8 Iocknuts from parts
bag. Tighten securely.
1.
Hook
2.
Discharge Chute
3.
Back plate slot
3
Replace discharge chute into roar opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
24
Advertisement
