Installing Ip Phones Through; Installing Ip Phones Through Overlays; Procedure 27 Installing Ip Phones Through Overlays - Nortel 1000 Branch of?ce Installation And Commissioning Manual

Installing IP Phones through LD 11
To use the Virtual Office feature at the Branch Office in Local Mode, a
Station Control Password must be configured. Refer to
"Setting and changing the Station Control Password Configuration" (page
216)
prevent user password confusion, Nortel recommends that the same SCPW
be used at the main office and the Branch Office.
Procedure 27 "Installing IP Phones through overlays" (page 279)
the general method of installing a Branch User IP Phone through LD 11.
If the installation technician uses TM 3.01 or LD 11 to configure the Branch User
ID and Main Office TN for an IP Phone, the IP Phone is automatically redirected
to the main office after it is registered to the Branch Office.
Procedure 27

Installing IP Phones through overlays

Step
1
2
Copyright © 2007, Nortel Networks
.
c. Press the Select soft key.
This reregisters the telephone at the main office.
If Resume Normal Mode is not selected, the IP Phone automatically
returns to Normal Mode after ten minutes.
to provision the Station Control Password at the Branch Office. To
Action
Configure the Branch Office zones and dialing plan. See
23 "Configuring the MG 1000B zone" (page
procedure on the MG 1000B Call Server.
Configure the following telephone data in LD 11:
• Terminal type
•
Customer Number
• TN
• Zone
To automatically redirect the IP Phone to the main office, configure a
BUID and its MOTN. The BUID and MOTN prompts are unique to the
Branch Office feature. Leave the MOTN field blank if it has the same
value as the Branch Office TN. If a BUID is not entered, MOTN is not
prompted. In this case, Branch User configuration is still required.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
Installing and configuring IP Phones 279
—End—
ATTENTION
Procedure 11
describes
Procedure
257). Perform this