Adding A Branch Office; Contents; Introduction - Nortel 1000 Branch of?ce Installation And Commissioning Manual

Adding a Branch Office

Contents

This section contains information on the following topics:
"Introduction" (page 191)
"Implementation summary" (page 194)
"Adding a CS 1000 Release 5.0 Branch Office to a Branch Office network with
previous releases of soft" (page 196)

Introduction

To install a Branch Office:
Step
1
2
A CS 1000 Release 5.0 Branch Office can only be added to a CS 1000E or
1000M main office running CS 1000 Release 5.0 software. However, branch
offices already existing in the network can be running a previous release of
software. In this case, you must choose whether or not to upgrade the set
Copyright © 2007, Nortel Networks
.
"Main office requirements" (page 192)
"Branch Office requirements" (page 193)
"Upgrade the entire network to CS 1000 Release 5.0" (page 197)
"Upgrade only the main office to CS 1000 Release 5.0" (page 198)
Action
Upgrade the main office to CS 1000 Release 5.0 software. For
more information, refer to Communication Server 1000E Upgrades
(NN43041-458) or CS 1000M and Meridian 1 Large System
Upgrades Overview (NN43021-458).
Configure the Branch Office implementation parameters at the main
office before installing the Branch Office. These parameters are the
dialing plan, zone parameters, IP Phone parameters, and passwords.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007
—End—
191