Nortel 1000 Branch of?ce Installation And Commissioning Manual page 320

320 Emergency Services configuration
4
LD 24 Configure Emergency Services Access.
Prompt Response
REQ NEW CHG
TYPE ESA
CUST xx
xxxx
ESDN
ESRT
0-511
0-127
x...x
DDGT
x...x
DFCL
OSDN x...x
5
LD 117 Configure Branch Office zone ESA route.
Command
CHG ZESA <Zone><ESA Route #><AC><ESA Prefix><ESA Locator>
Copyright © 2007, Nortel Networks
.
ESA uses a route number rather than ESN route list index. However,
ESN is required at the Branch Office.
Configure Emergency Services Access (ESA) in LD 24.
Configure an ACD number as an Emergency Services Directory
Number.
Description
Add new data, or change existing data.
Emergency Services Access data block
Customer number as defined in LD 15
Emergency Services DN (for example, 911). Up to four digits
are accepted.
ESA route number
Range for Large System and CS 1000E system
Range for Small System and Media Gateway 1000B
Directing Digits (for example, 1, 11, or 911). Up to four digits
are accepted.
Default ESA Calling Number. The input must be the following
lengths:
• On a system that is not FNP equipped, 8 or 11 digits are
accepted if the first digit of the input is "1"; otherwise the
input must be 7 or 10 digits.
• On a system that is FNP equipped, up to 16 digits are
allowed.
On-Site Notification station DN. The input must be a valid
single appearance internal DN.
Configure the Branch Office zone on the main office.
a. Configure the Branch Office zone's ESA dialing information in
LD 117.
Description
Defines the ESA parameters for the Branch Office zone, where:
• Zone = Zone number for the Branch Office.
Nortel Communication Server 1000
Branch Office Installation and Commissioning
NN43001-314 01.02 Standard
Release 5.0 20 June 2007