T-20 Screws; Cable Clamp - HP Surestore 100st - Archive Server Conversion Instructions

Figure 3-8 Removing the Drive From the Drive Enclosure
6. Mount a new drive into the drive enclosure.
a. Place the new drive into the enclosure at the top position (see Figure 3-7).
b. Remove the adhesive backing on the plastic cable clamp and position the
c. As you connect the drive interface cable to its connector on the rear of the
d. Replace the top and bottom cable access panels. Secure them with two T-10
e. Slide the enclosure into the chassis and secure the enclosure to the chassis
Converting 2.6 Gb Drive Jukeboxes to 5.2 Gb Drive Jukeboxes
Secure with two T-10 screws on each side.
clamp on the rear of the drive as shown in #1 on Figure 3-7.
drive, slide the cable into the cable clamp.
screws apiece (see #1 and #2 on Figure 3-8).
with one T-20 screw (see Figure 3-9).
Replace 2.3 Gb Drives With 5.2 Gb Drives
3-11