Port Fencing Configuration Using Bna; Table 21 Recommended Port Fencing Thresholds - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

TABLE 21
Area
Cyclic redundancy check
(CRC)
Invalid transmission word
(ITW)
Link reset (LR)
State change (ST)
Class 3 frame discard due
to timeout (C3TX_TO)
Enabling port fencing
1. Connect to the switch and log in as admin.
2. Configure port thresholds. Information about how to configure port thresholds is detailed in
3. Enter the portFencing --enable command. For example, to configure port fencing on an
Disabling port fencing
Use the --disable option to disable port fencing for the specified areas on all ports of the specified
port types. Use the --show option to display the configuration. The display includes the configured
port types, error types, and port fencing status (disabled or enabled). Port fencing is disabled by
default.
1. Connect to the switch and log in as admin.
2. Enter the portFencing --disable command. For example, to disable port fencing on an FOP_Port

Port fencing configuration using BNA

The Brocade Network Advisor (BNA) Management application supports port fencing. Port fencing
objects include the SAN, Fabrics, Directors, Switches (physical), Virtual Switches, Ports, as well as
Port Types (E_port, F_port, and FX_port). Use port fencing to directly assign a threshold to these
objects. When a switch does not support port fencing, a "No Fencing Changes" message displays in
the Threshold field in the Ports table.
If the port detects more events during the specified time period, the device firmware blocks the
port, disabling transmit and receive traffic until you investigate, solve the problem, and manually
unblock the port. Physical fabrics, directors, switches, port types, and ports display when you have
the privileges to manage that object and are indicated by the standard product icons.
Fabric Watch Administrator's Guide
53-1002752-01
Recommended port fencing thresholds
Moderate/recommended
threshold
Chapter 7, "Port Monitoring".
FOP_Port for the Class 3 discard frame area:
--
portFencing enable fop-port -area C3TX_TO
for the Link Reset area:
--
portFencing disable fop_port -area LR
Aggressive threshold
Low 5 Low 0
High 20 High 2
Low 25 Low 0
High 40 High 25
Low 0 Defaults
High 5
Low 0 Defaults
High 7
Low 0
High 5
Port fencing
Conservative threshold
Low 5
High 40
Low 25
High 80
Defaults
Defaults
N/A N/A
7
71