9
Fabric Watch Configuration Using Web Tools
Configuring alarms for FRUs using Web Tools
Configuration for the FRU class is different from configuration for the other classes. Because FRUs
are not monitored through a threshold-based system, they have a simpler interface for
configuration.
For FRUs, you configure the states for which an event occurs, as described in the following
procedure.
1. Open the Fabric Watch window.
2. Select the Threshold Configuration tab.
3. In Fabric Watch Explorer, select a FRU class.
4. Under Area Selection, select a FRU type from the list.
5. Select the alarm states for which you want an event to register.
6. Select the methods by which you want to be notified about the FRU alarms.
7.
8. Click OK to save the changes to the switch.
Configuring alarm filters using Web Tools
The Fabric Watch dialog box provides GUI support for the CLI command fwalarmsfilterset. This
option is used to configure the alarm filtering for Fabric Watch. By disabling the alarms, all
non-environment and non-resource class alarms are suppressed. By enabling the alarms, all class
alarms are generated.
To configure the alarm filter, perform the following steps.
1. Open the Fabric Watch dialog box.
2. Select Configure > Alarm Filter > Enable.
3. Click Yes.
92
If a FRU of the selected type is determined that it is one of the selected states, an event will
occur.
For FRUs, the only options are error log and e-mail alert.
Click Apply to apply the changes to the switch.
A confirmation dialog box displays, asking if you want to apply the changes to the switch.
A confirmation message displays, stating "Do you want to enable the Fabric Watch Alarm
Filter?"
Fabric Watch Administrator's Guide
53-1002752-01