Viewing Routing Path Information - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Example:
switch:admin> dlsshow
DLS is not set
switch:admin> dlsset
Committing configuration...done.
switch:admin> dlsshow
DLS is set
switch:admin> dlsreset
Committing configuration...done.

Viewing Routing Path Information

1. Log in as admin.
2. Enter the topologyShow command to display the fabric topology, as it
Fabric OS Procedures Version 3.1.x/4.1.x User Guide
appears to the local switch.
The following entries appear:
Local Domain - Domain number of local switch.
Domain - Domain number of destination switch.
Metric - Cost of reaching destination domain.
Name - The name of the destination switch.
Path Count - The number of currently active paths to the destination
domain.
Hops - The maximum number of hops to reach destination domain.
Out Port - The Port that incoming frame will be forwarded to, in order to
reach the destination domain.
In Ports- Input ports that use the corresponding Out Port to reach the
destination domain. This is the same information provided by
portrouteshow and urouteshow.
Total Bandwidth - The maximum bandwidth of the out port.
Bandwidth Demand - The maximum bandwidth demand by the in ports.
Flags - Always 'D', indicating a dynamic path. A dynamic path is
discovered automatically by the FSPF path selection protocol.
Basic Switch Management
67