Changing The Admin Password In V4.1 Firmware - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Changing the Admin Password in v4.1 Firmware

The following procedures is specific to v4.1 firmware.
For security reasons, the first time you log in to the Fabric OS you are requested to
change the admin system passwords. There are four user levels: root, factory,
admin, and user. Most of the administration of an HP SAN or Core switch should
be done from the admin user level.
Note:
To change the admin password:
1. Log in to the switch as the admin user.
2. Enter the passwd command. You are then prompted for information to
3. At the Enter new password prompt, enter the new password.
4. At the Re-type new password prompt, enter the new password exactly
5. Press the enter key to commit the configuration to the firmware.
Example:
switch:admin> passwd
Changing password for admin
Enter new password:
Re-type new password:
Password changed.
Saving password to stable storage.
Password saved to stable storage successfully.
switch:admin>
Fabric OS Procedures Version 3.1.x/4.1.x User Guide
You cannot reuse the default passwords.
change the password.
as entered at the previous prompt.
A message displays the successful storage of the new password.
Initial Configuration
23