Adjusting Color Corrections For A New Surface; Enabling Password Protection - Epson PowerLite 7800p User Manual

Adjusting Color Corrections for a New Surface

Adjust the correction values if you're projecting on a new surface or in
a new location.
1. Press the
Wall Shot
while you're projecting an image. Wait for the Wall Shot status
screen.
2. Press the
Wall Shot
on the status screen.
Readjustment
You see a sequence of colors flash for about five seconds as the
projector adjusts the color correction values for the new
projection surface.

Enabling Password Protection

To prevent unauthorized use, you can assign the projector a password.
If you do, a screen will appear requesting the password whenever the
projector is plugged in. If an incorrect password is entered three times
in succession, the projector's operation is locked and the power cord
must be disconnected and reinserted to redisplay the password screen.
If an incorrect password is entered nine times in succession, the user
must contact the dealer to unlock the projector.
The default setting for the Password Protect function is off. Follow
these steps to turn password protection on:
1. Press the button on the remote control for about five
Freeze
seconds.
You see this screen:
Security Lock: Security Lock:
Password Password
button on the remote control or projector
button until you see
Wall Shot
Security Security
ON ON OFF OFF
Set Set
note
It's a good idea to write your
password down. Also, make
a note of the "Request
Code: xxxxx number that
appears in the Password
Protect Release screen. If you
do forget the password, you'll
need this code when you
contact the dealer.
If you leave the projector
plugged in, the Password
Protect Release screen will
not appear. You only need a
password if you unplug and
reconnect the power cable.
Displaying and Adjusting the Image
41