Output Waveforms During Lcd Controller/Driver Operation (1/2 Duty Ratio) - Fujitsu Semiconductor Controller MB89950/950A Hardware Manual

12.4.1 Output Waveforms during LCD Controller/Driver
Operation (1/2 Duty Ratio)
The display drive output is a multiplex drive-type two-frame a.c. waveform. In the 1/2
duty ratio mode, the only common outputs are COM0 and COM1. (COM2 and COM3 are
not used.)
I 1/2 bias, 1/2 duty output waveform
The maximum potential difference exists between a segment output and the corresponding common output
when the segment (LCD cell) is turned on. Figure 12.4-2 "Output waveforms, 1/2 bias and 1/2 duty ratio
example" shows the output waveforms for the display RAM contents listed in Table 12.4-1 "Display RAM
contents example".
Table 12.4-1 Display RAM contents example
Segment
SEGn
SEGn+1
−: Not used
Display RAM contents
COM3 COM2
− −
− −
CHAPTER 12 LCD CONTROLLER/DRIVER
COM1
0
0
COM0
0
1
251