Extension Power Cable; Installing The Driver - Fujitsu PRIMERGY LTO2 User Manual

1.3

Extension Power Cable

When connecting the power cable of the server directly to this product, there is a possibility that this
product cannot be installed correctly.In this case, use the Extension power cable supplied with this
product.
(When installing to PRIMERGY RX600 S2, because attaching the power cable of the server to this
product will interfere with the ventilation ducts on top of the server, make sure to use the power
extension cable supplied with this product).
Extension power cable
(supplied with this product)
Power cable of the server
1.4

Installing the Driver

To use Windows Backup
according to the following procedures using the driver floppy provided with the device.
*: Click the [Start]button → [Programs] → [Accessories] → [System tools] → [Backup]
1.4.1 Driver Installation (For any model other than
PRIMERGY FT)
For Windows Server 2003
1
Log on to the Windows Server 2003 with administrator privileges.
2
Click the [Start] button → [Control Panel] → [System] in this order.
3
Select the [Hardware] tab and click [Device Manager].
4
Double click [Other devices], and then double click [TANDBERG
TS400 SCSI Sequential Device].
5
Select the [Driver] tab and click [Update Driver].
The "Welcome to the Hardware Update Wizard" message appears.
Tape Drv LTO2 Ultrium2 200GB (rear)
(*)
for Windows Server 2003 or Windows 2000 Server, install the driver
1 Installing the Unit to a Server
E
49