Table of Contents
Advertisement
CHAPTER 10 UART
Table 10.4-4 Serial mode control register 2 (SMC2) bits
Bit
Bit 7
Unused bits
Bit 6
Bit 5
PSEN:
Operation enable bit
Bit 4
Reserved bit
Bit 3
RSEL:
UART/SIO selection
bit
Bit 2
Unused bit
Bit 1
PDS1, PDS0:
Bit 0
Input clock divider
selection bits
214
• The read value is indeterminate.
• Writing to these bits has no effect on the operation.
• This bit enables baud rate generator. Baud rate generator is stopped by writing "0" to
this bit after transmitting/receiving the current serial data, then disabled thereafter.
• Always write "0".
• The bit is used to select whether the UART or serial I/O uses the data and clock I/O
pins.
• The read value is indeterminate.
• Writing to this bit has no effect on the operation.
• These bits are used to select the clock prescaler of the baud rate generator.
Function
Advertisement
Table of Contents
