Figure 004-4 Switch Setting On The Sn610 Attcon (1 Of 2) - NEC NEAX 2000 IVS Installation Manual

NAP 200-004
Sheet 4/12
Installation of Peripheral Equipment
(3) Set the switch located inside the console according to the type of headset/handset connected. Refer to
ure 004-4.
• Slide the directory out of the way.
Then insert a flat screw driver's blade into the notched opening and apply light upward pressure
until the access panel is clear of the front lip. At the same time apply pressure (toward you) at
the rear of the pedestal to move the access panel.
DIRECTORY

Figure 004-4 Switch Setting on the SN610 ATTCON (1 of 2)

ND-45492 (E)
Contents
Static Sensitive
Handling
Precautions Required
ACCESS PANEL
CHAPTER 3
Revision 2.0
ATTENTION
Fig-
Page 63