NAP 200-008
Sheet 3/3
Mounting of Circuit Cards
(5) Install the Card Stopper according to the following procedure.
(a) Insert the left side of the Card Stopper to the slot for the card Stopper as shown in Fig. A of
008-3.
(b) Loosen the attached screw for the Card Stopper, and hang the right side of the Card Stopper onto the
screw. Then, tighten the screw as shown in Fig. B of
SLOT
CHAPTER 3
Page 144
Revision 2.0
Fig. A
PIM
CARD STOPPER
CIRCUIT CARD
Fig. A
Figure 008-3 Installation of the Card Stopper
Figure
CARD STOPPER
SCREW
ND-45492 (E)
008-3.
Fig. B
Fig. B
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
Figure
PZ-PW86