Configuring A New Lec Manually - Enterasys VHSIM2-A6DP User Manual

6. Use the arrow keys to highlight the ELAN Name field. Enter a name for the ELAN that is no
more than 32 characters in length. This step is optional, and does not have to be performed to
configure the LEC automatically.
NOTE: Steps
fields may be enabled, LANE 1.0 does not support the corresponding features.
7. Use the arrow keys to highlight the Selective Multicast field.
8. Press the SPACE bar to toggle between the options (Enable or Disable) until the desired option
displays.
9. Use the arrow keys to highlight the LLC Multiplex Capable field.
10. Press the SPACE bar to toggle between the options (Enable or Disable) until the desired option
displays.
11. Use the arrow keys to highlight the Topology Change Frames field.
12. Press the SPACE bar to toggle between the options (Enable or Disable) until the desired option
displays.
13. Use the arrow keys to highlight the LECS ATM Address field. Enter the ATM Address of the
LECS. This step is optional, and should be performed only when a specific LECS, out of
multiple servers, is desired for this LEC.
14. Use the arrow keys to highlight the ADD LEC command at the bottom of the screen and press
ENTER. The LEC will now be configured automatically by the VHSIM2-A6DP.

3.13.3 Configuring a New LEC Manually

To configure a new LEC manually, perform the following steps:
1. Ensure the LEC Administration screen is in CREATE MODE. If the screen does not display
"CREATE MODE", perform the following substeps:
a. Use the arrow keys to highlight the CREATE MODE command at the bottom of the
screen.
b. Press ENTER. The LEC Administration screen, in CREATE MODE, displays.
2. Use the arrow keys to highlight the LANE Version field.
7 through 12 are not necessary if LANE 1.0 will be used. Although these
LEC Administration Screen
Local Management 3-45