Table of Contents
Advertisement
Installing a VHSIM
7. Place the VHSIM2-A6DP behind the device faceplate as shown back in
8. Insert the connectors of the VHSIM2-A6DP into the host device connector pins on the device.
CAUTION: In
screw holes on the VHSIM2-A6DP to prevent bending the pins.
9. Press down firmly on the back of the VHSIM2-A6DP until the pins slide all the way into the
connector holes.
10. Secure the VHSIM2-A6DP to the faceplate using the screws saved in
11. Secure the VHSIM2-A6DP to the standoffs using the screws saved in
ELECTRICAL HAZARD: Ensure that the chassis cover is in place before reconnecting
the power cord.
12. Reattach the chassis cover to the device, reconnect the power cord, and reconnect the device to
your network.
13. Refer to
Chapter 3
Management.
2-12
Installation
step
8, ensure that the standoffs on the device align with the standoff
for instructions on configuring the VHSIM2-A6DP using Local
Figure
2-6.
step
5.
step
6.
Advertisement
Table of Contents
