Installation - Enterasys Matrix E5 5H152-50 Installation Manual

ELECTRICAL HAZARD: Only qualified personnel should install the module.
NOTE: Read the Release Notes shipped with the module to check for any exceptions to
the supported features and operation documented in this guide.
This chapter provides the instructions to install the 5H152-50 and 5H153-50 modules and optional
5PIM-02 and 5PIM-G06 port interface modules. The installation procedures for installing optional
GPIMs in the 5PIM-G06 are also provided.
A Phillips screwdriver is required to install options into the module. Follow the order of the
sections listed below to correctly install the module.
• Unpacking the Module
• Installing Optional 5PIMs
• Installing Optional GPIMs
• Installing the Module into the 5C105 MATRIX E5 Chassis
• Connecting to the Network
• Connecting Fiber Optic Cables to GPIMs
• Completing the Installation
(Section 3.1)
(Section 3.2)
(Section 3.3)
(Section 3.5)
(Section
(Section 3.7)

Installation

(Section 3.4)
3.6)
3
3-1