Introduction; Powering The Equipment; Switching On; Power Up Operating Modes - Ericsson RX8000 Series Reference Manual

3.1

Introduction

This chapter describes the features and options provided by the Front Panel menus
for controlling the RX8000 Series Receivers locally.
3.2

Powering the Equipment

3.2.1

Switching On

This equipment should not be operated unless the cooling fans are working and
there is free-air flow around the unit.
1. Connect all signal and power cables to the rear panel of the unit. All connectors
2. Switch on the AC power supply to the unit at the wall or rack outlet.
Note:
3. After a short period of initialization the following screen is displayed on the Front
4. During initialization, confirm that the Status LED is on and all Up, Down, Left,
3.2.2

Power Up Operating Modes

When the equipment is switched on it will assume the control mode that was set
when the power was turned off. This could be either:
•
•
See the following figure for an overview of the power up operating modes.
EN/LZT 790 0005 R1A
are described in Chapter 2, Installing the Equipment.
The RX8000 Series Receivers do NOT contain a power on/off switch.
Panel:
Right, Edit and Save pushbuttons are lit.
Local Front Panel/Web Browser control
Director NCP control.
he following figure for an overview of the power up operating modes.
Caution!
INITIALIZING
4.3.2 (Bank 0)
Chapter 3
3-3